Where is everyone #5
Discussion in 'Flatbed Trucking Forum' started by DDlighttruck, Aug 27, 2017.
Page 9087 of 21463
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
-
cke, 7-UP, Westbound23 and 13 others Thank this.
-
cke, 7-UP, Westbound23 and 13 others Thank this.
-
-
-
Enjoy dinner -
Didn't you say that the first one's only made a pop noise instead of a boom ?
Called them firepoofers instead of firecrackers ?cke, Westbound23, Tall Mike and 9 others Thank this. -
@stwik , I think it was you asking about how RGNs actually work. These pictures show my neck.
The first picture shows the big eyes and pins that you slide over when re-attaching, as well as the pivot shaft that runs horizontally just above the big eyes.
Second picture shows the rams that push against the deck.
Third shows that the rams push the piece inside the neck frame against the neck.
The picture below shows that pivot pin and the locking pin to prevent things from coming apart.
I forgot to get a good picture of the dogs that hold the deck height, but in the second picture you can see another shaft running horizontally just under the end of the rams. Once you have the deck lifted you rotate that shaft such that the dogs encounter the inner frame work, and then let the load rest against the dogs.
The manufacturers have a variety of ways to accomplish this, but in general all of the hydraulic detach RGNs work in a similar fashion. -
So much safer.
It's a good thing you were still evolving into the human form you have now.
Evolution is a good thing.
Especially when you had blown off 25 fingers before you learned to let go after lighting it. Luckily they all grew back.cke, Westbound23, Crusader66 and 9 others Thank this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 9087 of 21463