which is the best route i have pre hires with kllm and arrow. now i really wanna do flatbedding so i can stay active and work, but i know its slow so and wanna make money so would driving refer be better or is flatbedding holding its own rite now in the economy. thanks in advance for any input
flatbedding or refer
Discussion in 'Questions From New Drivers' started by TaylorMade407, Jul 16, 2009.
Page 1 of 2
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
If you like working and challenges....Flat bedding...
But.....people always have to eat too...... -
Although my preference is to reefer (note the "everyone's got to eat comment) I see more loads available on the DAT Boards for flatbed than anything else. I have not heard much good about Arrow though. Do some detailed research. Find some drivers in your area that work for them and ask them about Arrow. Same with KLLM. Though I have not heard much bad about them.
-
-
i forgot to mention i have a pre hire with ffe also how do u like em
-
thanks alot. i would like to here from the actual drivers but i cant find em
-
That is because they are cheap non paying loads that no one in their right mind would pull... So they put them up there hoping to find a desperate driver to pull that load at cost & some below cost... -
Flats you will get treated better. Reefers are kicked around like scum of the earth. Then there is that lumper situation..
-
thanks so basiclly ther is enuff work out there to survive?
-
Flats have slowed down a lot, but I haven't heard of any one going to a soup kitchen yet.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 1 of 2