New water pump yesterday and today

Discussion in 'Ask An Owner Operator' started by feldsforever, Jan 11, 2020.

  1. feldsforever

    feldsforever Road Train Member

    1,453
    1,440
    Nov 22, 2019
    0
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. Mattmanstroked

    Mattmanstroked Light Load Member

    185
    279
    Nov 24, 2019
    0
    New belt? Was belt aligned or off one groove on a pulley?
     
    Rideandrepair and mhyn Thank this.
  4. feldsforever

    feldsforever Road Train Member

    1,453
    1,440
    Nov 22, 2019
    0
    It was aligned when I left out. Sitting on highway. Waiting for the ta to get here. I did pull it to make sure it was "usual" or "normal" against the pull test
     
    Rideandrepair Thanks this.
  5. Mattmanstroked

    Mattmanstroked Light Load Member

    185
    279
    Nov 24, 2019
    0
    Any of the pulleys locked up or hard to turn?
     
    Rideandrepair Thanks this.
  6. feldsforever

    feldsforever Road Train Member

    1,453
    1,440
    Nov 22, 2019
    0
    Thanks to your question I just check. They. Are moving freely. But some of the belt is chewed behind the w/p. Also two of the three big hoses are sucked in.

    Also as I spun the pullies I side eyed them and they appear to be straight
     
    Rideandrepair Thanks this.
  7. Mattmanstroked

    Mattmanstroked Light Load Member

    185
    279
    Nov 24, 2019
    0
    The coolant hoses are sucked in?? Is it full of coolant. Usually hoses get hard with coolant pressure that increases with heat.
     
    Rideandrepair Thanks this.
  8. baha

    baha Road Train Member

    4,137
    2,836
    Jul 25, 2013
    ga
    0
    Please try to turn the center of a/c compressor to be sure it turns ?
     
  9. AModelCat

    AModelCat Road Train Member

    29,140
    158,341
    Jul 7, 2015
    Canuckistan
    0
    Rad hoses collapsed while it was shut off and cooling down? Rad cap is the usual suspect in that case.

    Serpentine belts cannot tolerate very much misalignment. A very miniscule amount is all it takes for them to skip. Lack of belt tension and worn pulleys can cause that issue too.

    Was the belt removed to repair water pump? Possible it was routed incorrectly upon installation?
     
    Rideandrepair and mhyn Thank this.
  10. Gumper

    Gumper Road Train Member

    1,579
    3,843
    Jan 7, 2018
    Butte, MT
    0
    It appears your serpentine belt is broken
     
    Rideandrepair Thanks this.
  11. feldsforever

    feldsforever Road Train Member

    1,453
    1,440
    Nov 22, 2019
    0

    Thank you I needed that
     
    Rideandrepair and Gumper Thank this.
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.