I have a problem with a blend door Defrost/Dash vents, it stays on vents. I tested the voltage at the actuator plug and eliminated the controls. removed the actuator and tested it with a 9v battery as shown on Utube and it was bad. Replaced the actuator only to find that the blend door shaft was stripped out. I have tried wrapping teflon tape around the shaft, but the female side is to stripped out. Can this be glued and then calibrated? I have seen several posts about how to calibrated the doors, but none specifically for the Kenworth. Is this something I can do or will it have to be taken to a shop and calibrated thru the ECM? Any help would be greatly appreciated.
Stripped Blend Door 2014 Kenworth T680
Discussion in 'Trucks [ Eighteen Wheelers ]' started by AGY Guy, Sep 10, 2019.