So i bought 4 State Trucks
I'm really not that good with Electrical stuff.... It has 3 wires
Red,Green,White...
I Was wondering if i could somehow make them flash with my Turn signal? Also whats the best way to tap into the lighting in the rear on a T680?
Aftermarket Mud flap hanger..
Discussion in 'Trucks [ Eighteen Wheelers ]' started by TruckerPete1990, May 6, 2020.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
You'll need a half inch drill and a good drill bit. Get yourself some 4 pin trailer wiring, a butane torch and solder, some heat shrink tubes, wire cutter, strippers and about 2 hrs.
If this confounds you, you should maybe have someone else do it for you.haycarter and Caterpillar Cowboy Thank this. -
-
-
I put the same set on my freightliner. It used to have just the two center lights and the reverse light.
-
If the truck originally had 2 taillights that were stop, tail ,turn, just wire them up and they will function the same. If the truck originally had 4 tail lights 2stop 2 turn you will need to rewire the outside lights on the hangers for blinkers.
-
Red wire=Tail light
Green=turn
White=ground -
If you aren't good with electrical I'd let someone else do it. It's not a hard job at all but if you just hack into the factory harness and don't seal things up good you will have problems later on with wires corroding. Stop and turn signal lights are one wire, clearance or tail lights another and last is ground
-
Thanks I got them installed.
HoneyBadger67 Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.