no power at datalink port

Bias_racing · Jul 31, 2020

....

Bias_racing · Jul 31, 2020

Heavyd said: ↑

Ok, the anti theft you might be able to. If you have DLB, go into features and find the anti theft option. Anything that is installed on your truck will have a check mark. Uncheck the check mark and then select program. As for the Bendix adaptive cruise, at the dealer level, we do not disable this. This is hard coded in the Bendix module and a new Bendix module without adaptive cruise needs to be installed. Also, the engine has to be reprogrammed to eliminate this too and this requires engineering level access that only International has if you have an International engine. Not sure about Cummins.
Click to expand...

Not sure where my post went lol.

Anyway youre busting my chops that sucks. I just want to turn off the bendix its dangerous as hell and terrible to use if anyone is actually on the freeway. Would unplugging the radar just kill the cruise altogether?

On the alaram I've tried checking it. Im getting and error that says this program.has errors that need to be corrected before it saves"programs" its at the bottom.of the screen in like a blue footer. also this error too. they may be related.

Bias_racing · Jul 31, 2020

Got it squared

Westtec001 · Mar 3, 2022

truckerbangin said: ↑

95 intentional 9600 cab over with ddec iii 11.1 issue is (NO START)
i am getting no power at datalink port so i cant connect to ecm to use diagnostic link the truck has new timing sensors, fuel pump and, ecm and the truck still will not start.

how can i get power to DataLink port or does anybody have pin out of 6pin datalink port?
Click to expand...

I had the same problem with my 2020 Freightliner SD 122 after Safelite auto glass sliced through my ELD cable and I got a replacement there was no power, finally found the fuse it’s located in the panel behind the driver seat in the B post you open the door and lift the cover off of the fuse box that controls the rear of the truck there is a 10 fuse labeled DIAG/SP5 That fuse was blown as soon as I replaced it with another 10 amp fuse problem fixed.

Lockport · May 23, 2025

FYI: For those with this issue Western Star and Freightliner have a 10A fuse labeled Dataport, BAT. Likely at F25 in the fuse box in the dash.

Log in or Sign up

Forums

Find Trucking Jobs

no power at datalink port

Bias_racing Light Load Member

Trucking Jobs in 30 seconds

Wait, employers can't reach you!

Bias_racing Light Load Member

Trucking Jobs in 30 seconds

Wait, employers can't reach you!

Bias_racing Light Load Member

Westtec001 Bobtail Member

Lockport Light Load Member

Trucking Jobs in 30 seconds

Wait, employers can't reach you!

Log in or Sign up

Useful Searches

Find Trucking Jobs

no power at datalink port

Bias_racing Light Load Member

Wait, employers can't reach you!

Bias_racing Light Load Member

Wait, employers can't reach you!

Bias_racing Light Load Member

Westtec001 Bobtail Member

Lockport Light Load Member

Wait, employers can't reach you!