The pins can get stuck just from being pinched up against the rails. Rocking the trailer can free them. Theres only two directions you can rock it, and one of those directions is the direction you want to go. So if you nudge the trailer in the opposite direction first and then try to slide in the direction you want, you've rocked the trailer in both directions and this will often be enough to free the pins. If you listen you can hear them pop out while you do it. I haven't needed oil or a hammer in years, but then again the trailers I've pulled have usually been pretty well taken care of.
What do you do if you cant get tandems to slide
Discussion in 'Questions From New Drivers' started by Kolorado, Jul 14, 2021.
Page 2 of 5
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
bryan21384, Rideandrepair, truckdriver31 and 1 other person Thank this.
-
Sometimes when the tandems won't slide and if the pins are released then ya need to adjust your brakes. It's kinda hard to get em to slide if the brakes won't hold.
Trucker61016, Cabinover101, Rideandrepair and 3 others Thank this. -
Rideandrepair, Brettj3876 and slow.rider Thank this.
-
Yep, with heavy loads you can test brake chamber spring health pretty easy.
Several issues and different answers depending on system.
If you're brakes won't hold though, and you have a hand brake valve for your trailer, release the trailer brakes and pull your hand valve.
Application braking force is much greater than the force exerted by the brake chamber spring.Trucker61016, Cabinover101, Rideandrepair and 1 other person Thank this. -
My last few years before retirement I drove an auto-shift that was really sensitive. I also yanked a lot of junk. I kept 2 4X4s about 2 feet long and/or my chain bags IF I could not find a suitable curb. The process starts this way. Get out of the truck and spray the rails. I never bought the spray, I got it from the shop. Then allow the spray about 5 minutes before you start trying to rock the tandems. Inspect the locking pins CAREFULLY because sometimes they only look like they are fully retracted. This is why I used a Ball Peen hammer because I could hit the pin and not the rails. Work the tandems until you can see some movement and hopefully the spray will loosen the rails up. This is where a lot of rookies burn up a clutch. At some point, if those tandems are so recalcitrant you are either smoking a clutch OR the auto-shift safety engages, you are going to have to seek help. Years ago I was at the Hershey western warehouse in Utah doing a drop and hook. After about 20 minutes I had to call my company. That trailer was so screwed up it took about 3 hours for the mechanic to fix it.
Rideandrepair Thanks this. -
Last edited: Jul 15, 2021
Rideandrepair and tscottme Thank this. -
If you can’t get the pins to retract with the old lever style because they are jammed up against the edge of the holes do a couple of figure 8’s with the truck and trailer. 99 percent of the time it will free the pins up and you can lift the lever with ease.
Crassius and Rideandrepair Thank this. -
Rideandrepair Thanks this.
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 2 of 5