Where is everyone #5

No sir I’m building a C model for a forum member is all I’m at liberty to say. It’s not gonna be Bilt to the Hilt but still have the same love and pride I put in all of em that come outta here.

it’s a big pin 3ZJ
Put deck rings in the block then trued the top. Lowers looked really good
Went with the enhanced durability C model kit raised edge liners. New head. New 8785 nozzles. I had a turbo built for it. Steed speed manifold. Dual thermostat conversion, done the idler gear and worked the timing advance and pump over. All new springs, servo governor shaft as well as plungers and barrels. We’re sorta putting the finishing touches on it. Last one I done this way a while back was really nice. He’s put 15k miles on it with 0 issues hopefully this one turns out the same

 

Dang! Definitely room in there if it's as wide as it appears. Nice snag!

 

I've done some sketchy stuff. This isn't even close to it. Not really sure why the people on F@*$book are up in arms about it.

 

I didn’t even look at the comments. People on facebook are so full of ####. 90% are ####ing posers anyhow.

 

That's cool as hell , hard to tell in the video. Looks like they got it just welded to a old steel wheel ? That would actually work pretty dang good for me

 

I love reading some good comments.

 

You installing one of their manifolds on a 3406?

 

Yes

 

Seemed most were concerned about a parking brake. Like wtf! Are these morons talking about. Then someone said homemade tools and osha don’t mix. Idgaf about osha. I doubt any guy with a shop in his backyard does.

 

I did see a piece of one said something about the wheel studs weren’t designed for that yada yada. Haters gonna hate