HAZMAT Virgin(s) Need Advice

Every hazard classification has a 'generic' description of sorts, including wastes.

It may fall under one like Hazardous waste, solid, NOS, and require additional information describing the hazardous element. The NOS means 'not otherwise specified [by name]'

 

Here's one place for you to start, FMCSA. I don't know where you have been looking so far. I haven't dealt with Haz Mat since before the changes after 9/11, so I'm really, really rusty on it!

 

Since this is a forum and not a week-long seminar I'll try to briefly point you in the right direction.

1. Spent fluorescent light tubes are RCRA regulated hazardous waste. You are about to enter the EPA's world (although you don't get to leave USDOT's world).
2. EPA's hazardous waste regulations are found in 40 CFR.
3. Your company will be defined as a hazardous waste transporter.
4. As a transporter the USEPA requires that your company
a) Obtain an EPA Identification Number
In Florida you can get your EPA ID Number from:
Florida Department of Environmental Protection
MS 4555
2600 Blair Stone Road
Tallahassee FL, 32399-2400
850-245-8748
b) Comply with the manifest system (the waste generator is responsible for properly classifying the waste and completing the manifest. The Uniform Hazardous Waste Manifest will serve as your shipping paper and has specific disposition and retention requirements)
c) Respond appropriately to Hazardous Waste Discharges (this will require some training of employees).
d) Comply with all applicable USDOT regulations. Because the PHMSA regulations (49 CFR 171 - 179) include hazardous wastes in the definition of Hazardous Materials, the haz mat regulations apply.

Hope this helps.

 

Other links on that page I linked to will give you the pages to get set up with your DOT number. That can even be done online now.