Torque is just a number, horsepower makes the work. When the torque goes up, so does hp. HP= Torque x rpm
Scania v8 730hp
Discussion in 'Trucks [ Eighteen Wheelers ]' started by 98989, Apr 16, 2010.
Page 64 of 103
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
-
Im pretty sure that hp is calculated from the torque readings, the torque I believe is the actual twisting force on the crank shaft, ( like an airgun for removing your tyre, it will have the torque force marked on it) torque is the all important figure . I've always suspected Volvo put higher hp badges on the trucks than they actually producing. My 420 hp scanias would hold into the 460 hp volvos on any hill, an old 143 450 hp would annihilate them! That's why I always kept the volvos on light work like dry freight and used the scanias for fridge and livestock work.
-
here we dont have such advanced trailers we mainly use truck +full trailer setups not semitrailers and we haul only short logs
but drawbar trailer fallows truck very good
here we also have many similar tight places , and since forest jobs here are not large forest road are very bad
also here we have many overloads it is normal to load 80-90ton on 5axle or even sometimes up to 110tons on 6axles all with twin tires so soil is very soft and truck can sink on one side and with high center of gravity it is easy to roll over ..... -
they did it recently and all get 8-12hp more than before
so as i already wrote now fh(13) 540 is 550hp
fh16 600 is now 612hp .....Scania man Thanks this. -
The formule when using Newtonmeters is: HP = Nm x rpm / 7019
So let's take 3500 Nm at 1200 rpm: 3500 x 1200 / 7019 = 598 hp
Then 730 hp at 1800 rpm : 7019 x 730 / 1800 = 2847 Nm
Torque is a static number but piston engines must be spinning to make any torque so there's always also hp. Electric engines can make torque at zero rpm but then they don't have any hp.
Torque per hp is useless comparison.Scania man Thanks this. -
as for the protection scania mainly use http://www.akerskrutbruk.se shield
i have seen only french army use different shield
also read
http://www.akerskrutbruk.se/website1/10.0.1.0/27/ak_report_new.pdfLast edited: Sep 10, 2011
-
Today it's September
11th, no matter what your beliefs are today is the day we show our respect as gentlemen and ladies to our fellow friends and colleges on this forum, Today we ain't Americans and Europeans : today we are all colleagues , we all know of a fellow countryman lost in 9/11, bit today we are truck drivers, today we are friends!C16KIWI Thanks this. -
I got a proper drive of an r730 today, holy sh**, the power is mental! The little finishing touches make it feel special too, 41 tons on it today , I could slow right down behind other trucks on steep hill then just drop half a gear and accelerate as if it was empty, unbelievable ! The two pedal auto is nice too but I think I'd like a clutch pedal too, I'm not sure if it's as light on fuel as they say, I got 9 mpg but then again I was getting carried away with the power messing around so that may not of helped
-
i would like also to have 3pedal opc it is more stupid but cheaper ( 965€
and i believe that clutch life and life of synchros are longer
than on 2pedal, also less parts to brake down
i have seen opc without clutch only 3times until now
( on r400 highline and r480 topline from presenting of new r series and on r440 highline as scania demo truck)
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 64 of 103