Has anyone replaced one? How bad of a job is it? The plastic clip that locks onto the metal arm coming out of the column is worn / cracked. It looks like the previous owner had an issue once before. The handle could ultimately be epoxied in place. But how hard is it to just replace it?
Does anyone have the correct part number for a new turn signal handle?
Thanks - Todd
07' Volvo 780 Broken Turn Signal Lever / Handle
Discussion in 'Volvo Forum' started by wolf river, Mar 26, 2012.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Use any from verson-2. Old had different connectors, so let dealer find part with VIN, elsce you have to get heat shrink, cut wires and swap connector.
Turn signal lever may be with c/c and w/o, really volvo used these switches on old volvo cars -
Thanks I have a issues that pops up once in a while. You might know or be able to point me in the right direction. Only happens at take off or very low speed from a start. All of a sudden fuel pedal is inoperative - does nothing at all and looses power. On the dash the seat belt light is on but the seat belt(s) are both being worn. Turn the key off and restart no problem. This has happened a couple of times in the last month. No real set circumstances to make it happen? Any ideas? The truck will be home tomorrow night so I figured I would take a look at it. It went out as a solo for a few days.
Thanks - Todd -
J1939 issues usually. bad wiring
-
ouh. check VECU for last fault codes. Gas pedal is not too reliable part. Idle switch goes bad in 500 k miles
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.