Minor annoyance....
So I route from Guymon, OK to Austin, TX using freeways- allow all. Calculated route looks good on the paper map and I'm off. Stop in Childress, TX and the device decides to re-calculate the route to something longer with the same settings. This does not happen much but it does happen on ocassion. Any explanation for this behavior? The last time it occured, I had saved the orginal calculation and just re-implemented it. Yes- I am aware of the spelling issues in this post- technical issues.
Mark W.
Suppport Thread for the TND 500, TND 700 or future Rand McNally products.
Discussion in 'Trucking Electronics, Gadgets and Software Forum' started by Mark Kling, Apr 16, 2010.
- Thread Status:
- Not open for further replies.
Page 478 of 756
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
I have a TND 510 and so far I have zero (0) confidence in it. After several aggravating situations I have managed to get into with the ever helpfulness of my gps, I am going to start posting issues I encounter.
Tonight for example, I am at the I-90 Truck Stop in Mitchell, SD. I chose this location due to the fact I was low on fuel and driving hours. My gps showed this location to be a pilot, which I get a fuel discount at. Found out this is not a Pilot but an AmBest.
I understand things change, but by appearances, this has been an AmBest for a while.
yes, my gps has been updatedLast edited: Oct 15, 2012
-
This was a pilot. It is now an indie. it changed over about a year ago. The old Sinclair truck stop in Murdo, SD is now a pilot -
Thanks,
Mark -
If you continue on your first route it should recalculate again to the route you are on.
Thanks,
Mark -
Is there a way to change the two maintenance odometer descriptions?
My wife didn't know I already had the garmin dezl and I came in for hometime to find a new 720 I'm gonna run it side by side with the dezl for a while and see which one I prefer so far I like a few of the features really like the part where you can search stops along your route where with the garmin I gotta keep selecting till I find one one route
But would be nice to change say maintenance 1 to say maybe pm due or what ever
Thanks -
As I mentioned, this is a relatively rare occurrence. But is does happen.
Mark W. -
Make sure you register for the LTM's.
Thanks,
mark -
A lot of what goes on internally I cannot talk about.
Thanks,
mark -
ThanksMark Kling Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 478 of 756
- Thread Status:
- Not open for further replies.