Schneider chat room - Closed see new thread linked in the last post

not true. Mine gets changed back to original for all stops when I recieve a new preassignment in particular the last stop which for me is always a drop empty back at JCP.

As for the rest , thats what I understand the times to be going forward.

 

We always changed our ETA at our last comfort stop before delivery, and we never accepted a new assignment until we were done with the one we were on.

 

This isn't true. Whenever you are in the middle of an assignment and changes are made to it, for example, you go to pick up an empty trailer and there are none, so they have to add another stop in after the fact so you can get an empty elsewhere. Whenever this happens and they change the work assignment in the middle of the load all of the ETAs and your NAT gets changed by them OR the system just defaults back to the original ETAs that the system assumed you'd have. So no, the ETAs can and do get changed around by people other than you.

 

Hence my point that the system is flawed.

Sent from waterproof phone using Tapatalk 2 Blue

 

That is true

 

Still in Laredo finally got a assignment to get out of here but sat so long after my 2 mile relay that had to be done first thing in the AM I'm just going to sit a few more hours and run at night now. If it wasn't for that relay I could of just waited till morning and got a fresh 70hr clock now I'll be in MS with 11hrs on my 70 and 700 miles from the house LMAO So with all my new found time off today I talked to some people and fired off an application.

 

dumb question here. what are the chances if i come back to schneider that ill get one of the newer trucks? i heard they ordered like 3000 trucks within the past yr or so....

 

They had a couple loads going out of laredo yesterday and today on the choice board

quad core project butter smoothness

 

Roll the dice and find out

quad core project butter smoothness

 

i should of included this question. is it better not to get a newer one? something about sensors etc?