My truck lights aren't working, well my brake & turn signal lights work but that's all that works! Is there a fuse or relay I can change! If so where? Trailer & everything else work fine! My truck is an 07 Volvo! Thanks
Truck lights not working!
Discussion in 'Volvo Forum' started by 325TahoeSS, Mar 11, 2013.
Page 1 of 2
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
pull out your center cup holder.. right under your cupholder you'll see 2 screws, take them out and it will lift up,,(put your cb to the side) you will see your fuses there,(go on YOUTUBE and type in fuse box for volvo 670 and you can watch it how its done) hope this helps!!
mje Thanks this. -
Thanks I know where it is, I was just wondering if anyone knew what fuse number or relay it was to get then working again!mje Thanks this.
-
There is a scamatic on the cover to show you every fuse and what it operates, there should be a little tweaser looking thing in there too. Try a test light on each one you suspect.. I think this should help you.mje Thanks this.
-
I tested EVERY fuse & still can't find out what's wrong!
mje Thanks this. -
hi is it the rear lights are not working or front? if you have a problem with lights on the back and can't find the problem, also have message check light control module best thing is to try to replace the wiring from the last harness to the lights on the back. Just recently have that problem my self.
Last edited: Mar 12, 2013
mje Thanks this. -
The rear! The brake lights & turn signal work but the night time running brake lights aren't workingmje Thanks this.
-
could it be something as simple as the light itself? Have you taken a spare and replaced to see if it was the light itself?? You should have 3 wires on the harness plugged into the light. One is for signal, other for brake, other for the light. The one for light may be shorted??? I just replaced one with same problem 1O minutes ago..
-
It can be taken apart and you can solder new plugs on the harness but use waterproof marine grade heat shrink or you will have to do it again. Good Luck!
-
Check if u have power coming in at the 5 pin connector of the harness if u have you're 4 ways running you're going to have the two signals and there should embe one more constant power if the lights are on if u have power at the 5 pin connector then there is a splice in the harness where the light split up between left and right that it goes bad you ll see it if u open up the tape from the 5 pin connector towards the lights
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 1 of 2