Suppport Thread for the TND 500, TND 700 or future Rand McNally products.

No way to really put a trip on hold. You can add the truck stop as a Via or turn the recalculation to Manual (Preferences/General/route). This will basically keep the same routing when you pull off to an unplanned stop in your route. Note - turning the unit off and on again, it may pick a different route that the one you were on.

You can normally build a trip and if you add via points, go to Choose destination/Multi-Stop trips/Current trip and do a Save As and save it to another folder. Then when you turn the unit off/on, go back to the same screen and pick your trip folder. Do a Start Trip from this folder and then modify the current trip folder for the locations you do not need anymore.

Thanks,
Mark

 

PM me your address. I did a Save As on the installer and it is only about 15.6 mb. Part of the space needed for the installer will be a backup of your TND which is about 3.5 gb...

Do you have LTM's?

Thanks,
Mark

 

Part of the issue being once the installer runs it will draw more files from the Dock Server.

I will send you the installer, but suggest you contact your service provider and see what the cost is for going over your limit. Usually if you have a Data Plan they will charge your $x per GB over.

Thanks,
Mark