I 95 n Maryland
Discussion in 'Questions From New Drivers' started by Plumberboy2011, Aug 18, 2016.
Page 1 of 2
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
You overweight homie?
-
No went through the tunnel and my way through the tunnel my gps started screaming at me there was a 5 ton weight restrictions on that section but it was too late I was in the middle of the tunnel it was like 2 in the morning so thee was no traffic I was just rollingGiuseppe Ventolucci Thanks this.
-
If the Lat/Long of that restriction is placed wrong in the map database you will get a message or if the Lat/Long is off some this will also cause warnings.
Which GPS? -
Nah, the only general restriction on the I-95 Baltimore tunnel is Hazmat. They probably don't allow over-sized permit loads either due to height and width limits.
Just take 695 around the Beltway. Saves the $24 toll anyway. -
I always take the beltway however it's a nightmare around 5pm on a Friday!
-
Harbor tunnel has 96" width restriction and no doubles and Ft McHenry only has Hazmat restriction.Better to just go around the West side and save Tolls
-
Better yet, take 301 and miss Baltimore.ore completely along with ¾ of the DC Beltway, and the tunnels, and the toll at the tidings bridge, and the tolls at the Delaware Line... Only one toll on 301.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 1 of 2