Support Thread for the TND 500, TND 700 or future Rand McNally products. (part two)

Yes per the hardware engineer... I have not tried anything bigger yet to see if it works.

Thanks,
Mark

 

Call 877-446-4863 and let them know you need a replace 740 Slice. Be sure the 740 is registered online.

Thanks,
Mark

 

An issue was brought up that if Tolls are set to Avoid that it actually put you on a Toll "route". In further digging into the Map Data, yes there is a Toll Bridge, but not a Toll Road. HERE does not mark Toll Bridges as Toll Roads, so in the software if you set Tolls to Avoid it will avoid Toll ROADS, but not avoid Toll BRIDGES if no Toll road is associated with it.

You will get a Toll Cost Pop up since the Toll Bridge does have a Toll Cost associated with it.

This is being looked at.

Thanks,
Mark

 

I just found out they had replacement slices...

Thanks,
Mark

 

edited

Thanks,
Mark