Got a bad case of the wiring demons....... Help please

Thanks!

trying to cipher that print...... lol

going from left to right in the middle, I'll tell you what I think the colors are if you could check what I see I'd appreciate that.

OR-W = orange & white (there's orange, no white) left turn hood & front

V-B, = violet & blue (there's blue, no violet), right front hood & front

Y-BK = yellow & black (there's a black and a yellow), left rear stop turn

GR (I think) = green, (there's no green) right rear stop turn

then further to the right there's

V-BL = blue, v? customer access right turn stop

BR-V = brown , v? (there is no brown) customer access left turn stop

so, what is in and what is out and what about the colors that aren't on this signal stat?

Thanks

 

We decided to just run 2 sets of lights like swaan said. Ran 3 new wires to the back.

Brake lights are red wire on signal stat

Right turn is blue on signal stat

Let turn is orange on signal stat

Now we have all turn lights working when turn lights are only being used and all brake lights working when brake lights are used, but when we turn right turn on and brake lights on, we lose brake lights and right turn doesn't flash. There is no way we have any cross over in our new end of wiring, so stumped on that part.

Tried uploading a pic, but it says file is too big. Dunno why, can upload them pretty much every other place.

 

so anyone have any idea why when we turn right turn on and brake lights on, we lose brake lights and right turn doesn't flash?

Thanks

 

new signal stat hooked same as old one
signal stat colors are as follows and connected to
orange = green/white stripe
blue = white/green stripe
yellow = yellow/black stripe
red = green
green = green
black = black