Readings while cranking
Got an 01 int 4900 with a DT466 HT with a crank no start with no attempt to even try firing up. Will run on spray. Pre-egr and single engine...
Can't change the trim codes on this truck. It's deleted. Electrical system comes up as a Version 2.0 Instead of a 2.6 or whatever it should be. So...
Yes. We have tech tool. I've dealt with trim codes alot on CATS. I didn't know Volvos used them too. Do they send the trim file with the...
Find an independent shop, go to the bars near there, and bring it up in conversation lol. Either the local truckers will have brought stuff there...
I'd have to check on the trim code. Didn't know they used them. Do they send a file with the new injectors? If they do and it doesn't match is...
That thought has crossed my mind. It's a thick gritty wet buildup. New head though, but could be. Hell have had repeated turbos bad outta the box...
Got an issue I'm stumped on and don't have long time experience with the D13. Issue is cylinder 4 is smoking a bit with a little smoke and slight...
Looking to see if anyone has a pdf file of the advanced diagnostics and information on the internals of ZF Freedomline Transmission. Have the...
The air filter housing was already off, but after I got your comment I did take the entire air intake pipe with the egr valve on it off that heads...
Swapped idms, crank sensor, and all six injectors with no fix since last post. Officially stumped on this one.
Forgot to note that it doesn't smoke until icp pressure reaches icp desired pressure right before it fires up. Almost like the initial combustion...
Got an 2005 int 4300 with a DT466e with heavy fueling smoke only startup and long crank time. Runs good till warmed up then randomly dies....
Your brake light switch is worn out. If the brakes and pedal are fuctioning properly then the switch is bad.
Nvm mind. Skipped past a response when scrolling. I've never used the snap on scan tool so can't give much help on why that can see codes and...
Post a pic of the dash. I dont remember what year they switched from the square instrument cluster to the rounded one. I can get part numbers...
Adjustment for the clutch has to be done with the clutch pedal pushed in. Otherwise all you're doing is stripping out the adjusting screw. The...
Forgot to update...dug through the trash and found the original head gaskets. There's two types of heads for the 460s. Recessed ports or flats....
I am getting cooling system pressure coming out of the smaller ports on the heads that I have circled in the attached pictures. The head...
If ya got a manual unplug your speed sensor at the back of the trans. Itll get ya unloaded but youll lose your speedo
