here is a code list for cats
you need a retrofit kit to do away with that system. i have attached service bulletin for the installation. part number is 681 831 00 K0
no the top 2 gets shut off
we have not had any problem getting paid on warranty repairs from cat. they are asking us to do take a few more steps when we do a warranty...
what engine?
u-joint, rear diff input play are not dot items. not saying they don't need to be fixed. it would be cheaper to get fixed now then paying a tow...
no the c at the end is the gear ratio. the convertable trans would be a RTL0C-16909A or something like that. the C before the dash stands for...
here is the directions for adjusting a solo clutch. hopefully the tab still has enough meat left to use the tool.
make sure the vnt shaft in the turbo is tight. at the clevis u should not have any play where the shaft goes into the turbo.
just to replace sliding clutches, bearings, oil. you will be probally be looking around $2500. sometimes it may need gears just depends how bad...
we are working on a program right now to install dpfs on older trucks. its not going to be cheap to install but atleast we will have another...
i think you are going to see alot of people start refurbing older trucks. we just got done with 2 step vans and we have 5 more on the way. for the...
the sliding clutch is what engages the gear. its on the mainshaft and splined to the mainshaft. the outside of the sliding clutch has teeth on it...
sounds like u have a sliding clutch wore out.
yes, they are all the same rims.
their is a service bulletin on the cascadia for the windshields leaking. thier is 2 different seals. one seal you use one type of sealer and a...
i am going to need some 28' bread trucks (fed ex/ups type vans) hauled. 10.5 feet tall. could be 20 could be 200. just depends on thier condition....
how long has truck been doing this. did someone just reprogram ecm?
if u want give me your email and i can email the drivers manual to u.... it won't let me attach it for some reason. i will still work on getting...
the only problem u would run into is installing the new bushings and reaming them.. u could remove the spindles and take them to a shop that can...
