A lot of guys call the non EGR ISX's Signatures...since they basically are. With that said, I'd rather have a signature.....These emission...
No, I think just the E+......or maybe all the celect plus... If its not there, I wouldn't worry about it. If it was...it grounds to the top...
I don't know how some driver's will feel....but..... I think you should go to Cummins and pay the 250 to get it turned up. Doing things the...
Yeah, thats one problem I think everyone has experienced on a N-14 or M-11. First thing to check is the ground fuse for the ECM, its located a...
intake 0.014", exhaust 0.027", injector 71 in lbs, engine brake will depend on year... but pre '07 is 0.276
You sure do like to do a lot of assuming. Just because a circuit works the one time, it doesn't mean it will work the next. This is why it is...
ISX gear train is far superior to anyone else. Both Cat and Detroit use that ridiculous bull gear. But Detroit uses whats just like a wheel...
I don't work on freightliners a lot but......the last time I had one with an electrical problem like yours, I replaced the battery protection...
Good call, apparently I read over that :biggrin_25520:
I used to work for Kenworth and now work for Volvo. The T-600's are nice but I think the VNL series from Volvo has the best turning radius. And...
Sounds to me you have a coolant leak somewhere. Obviously, if you took off the bottom hose of the surge tank and had no coolant, there is no...
STC Valve needs adjusted.
Yes the wire does go back to the ECM. Now if you're not comfortable....let me know. The rear of the ECM is where the connections are. There are...
Tandems parellel to the frame? to each other? Maybe have a good truck alignment shop check it out. Also, don't forget the driveline phasing, not...
Insite (Cummins electronic diagnostic tool) won't be needed here. Throw me an engine serial number so I can be for sure on the pinouts, but what...
I would be careful. It takes a special Cat tool to set the cam gear backlash..although you could use feeler gauge. Other than that, its just...
The PX-6 (ISB) and PX-8 (ISC) are Cummins engines. It wouldn't surprise me at all if they have a PX-16 (ISX).
Yeah, looked it up. Looks like the 3406E 600 horse came out in 1997 and the Signature came out in 1998. I can't get em all right. Now I...
I won't disagree, the ISX blows holes in blocks more than any other engine I've seen. But like I said before, just as long as you take good care...
I would say the answer is pretty obvious. Cummins N-14 outlasts just about any engine out there. Fuel mileage is great and power is better than...
