Could I do the opposite and run power through the fuse side and use a test light to determine if the broken wire I suspect is for the temp sensor?
I found a wire I may suspect is for the temp sensor. Just a single wire that looks like a hot wire but can’t find a ground. Can I test this wire...
12 volts to solenoid shuts the fan down. I can’t seem to find a good fuse to start with. Would you happen to know which one of these fuses might...
Guess I’ll show how much of mechanic I’m not and tell you that the truck has an aftermarket temp gauge and there is nothing plugged into the block...
put air to it and the clutch released. A little resistance but it didn’t try to turn the entire engine. So the next thing I see down stream is...
I lied, I see a air line going into the clutch. The fan is very hard to move. Replace clutch?
Viscous fan I believe
Hello all, DT466 in the 94 international 4900. Engine fan is always on since I got the truck. Getting really annoyed with all the noise. Any...
There are periods of time when the engine will run incredibly smooth and quiet. Then it will run rough like it’s missing a little or injector is...
We have a 1994 international 4900 tandem axle dump truck. Solid truck, has the good old DT 466. Runs nice but it sees a hill from a mile away. I...
Yep the front cover is missing bottom bolt and the rear cover looks as if it’s leaking too but need to take the starter off for a better view. I...
Tightening these bolts won’t screw up the timing?
Hello, Was curious if the starter holds back engine oil on these motors? The starter bolts wiggled loose and it seemed to be leaking oil from...
You know it
ECM needed repaired. $1,000 and I’ll have it back on Monday.
Not sure if anyone is still following this thread but the ecm wasn’t responding. Sent it to Colorado to get tested, hopefully it’s repairable.
Scanned it today, code that popped up is 434 which is power supply lost with ignition on. Thinking it might be the smaller hot wire for the ecm...
I thought it said engine warning but maybe it was the stop engine light. When I took the fuel filter off the first time it was half full, I was...
Fuel shut off solenoid is at 12 volts, solenoid clicks when wire is touched. I keep thinking it’s a fuel issue...but it turns over exactly 3...
Sorry I haven’t had time to check the fuel shut off solenoid today, had to dig a pond. Wound up taking the air compressor, charging up the brakes,...
