I tested the continuity between the temp control valve and the ecm and there good. Does any know where the wires from the wires go from the low...
Not sure what that is?
To a ground
Ok this is what I found if I put a voltage meter on the temp sensor it reads 4.9-5 volts then it goes to 0 then to 1.00 then back to 4.9 until it...
Thanks
I totally understand it I wouldn't rebuild the engine until it was necessary but it does have 780+ miles on it and I don't want to be in the...
And if they are what else would you susjest?
Are they that bad that I will hate it?
Would the speed sensor have anything to do here? I peeled back the harness as far as I could and metered the wires and they check out
That's all fine but it weigh almost 24k and I can only scale 42k on a all aluminum flat that leaves me limited in the available loads. And the 3...
Yes it's a kysor and I replacer it...along with a new sender
Been there and done that . Changed all sensors,actuators, injectors, slowed down to 60 only gained .05 . Full fairings skyrise sleeper and I...
I tested voltage and ground on both coolant senders I don't have a skamatic to look at.
No it does this from the moment I start it cold
I'm looking on buying a newer truck I have a 2009 international prostar 485 cummins 13 spd 355 rears. When the truck was built it was built to...
Video won't post The gauge clicks up to 250 dash cel lights light up loose throttle and it dies. It is sometimes hard to restart.
1997 classic 12.7 series 60 temperature gauge goes to 250 dash cel,stop engine light I lose throttle and it dies. I have changed both sending...
I looked in the fuse pannle and the fuse for the pump was missing I replaced it and everything is working tanks equalized..thanks
Thank you Sir
Thanks for your reply after doing some diagnosis I found the fuse for the transfer pump to be missing so I replaced it and ots working. This truck...
