OMG. I dont know how i read his post and read over that. Sorry. Have alot of problems on my mind
How about a severly worn out sliding clutch and/OR the gear set it slides into?
Those trailers are squirley to begin with. I have personally seen one go over on a flat. Which you already know, It doesnt take much for one to go...
Well i suited up and pulled the hood off and yanked the radiator anyhow. So tomorrow morning should be pretty easy couple of hours. Just have to...
i would be working on it tomorrow if it wasnt so cold. i should make good progress on monday. gonna be warm. 32 dgrees
Well wish me the best man. IF its that bad, time for a new motor which would suck. Brought the air compressor back to peterbilt today
I though 30 min sounded kinda low as well for that thick of gear bore. Ok thank you Also, why cant i find any other cat engines that had...
This is for a 10" camshaft gear brotha. its big and thick. Manual calls for almost 600 degrees and couldnt find a toaster that hot
WAs thinking of using oil and camping stove to heat gear. But then i was thinking of putting propane cooking grill next to truck and heat gear...
any recommednations on a amazon hot plate to do this?
Ok and thank you for these tips Also, ill be bringing the compessor to peterbilt in te morning. more i think about it, more angry i get. There is...
i promise you, if i see any teeth damaged o the other gears whe i pull the cover, i will pull them. Found plenty of gears for ale without having...
I doubt there is a recall. I bought 8 new ones 2 years ago and installed, along with new cams. I did them myself per spec. Worked great for a few...
yeah ill drop the pan again too. Frst thing i did was did compressor. Next pulled pan and eplaced gasket Next pulled hood and installed pitts...
when i pull cover, i will definitely, pin the engine a tdc and check the timing marks on the gears to make sure it didnt skip timing. Any...
i might be replacing the idler n the passenger side as well as sprocket on crank. Wont know until i rip her apart Not costing me downtime. I...
dont know how to explain it. Freak accident. The bolt sheered off the snout that holds the gear on to the air compressor. I think it may have...
some users on here are funny i think and use grinder app i think
the old oil feed Oil by Don379 posted Jan 27, 2022 at 8:24 PM
i replaced the old unit just becuase i was doing preventative maintaanence and have the money and time right now. I swapped the gear on to the new...
