I am assuming on STUDS, he was talking about the mount that you screw the antenna into. I will look into the guy in Gary IN. I go through...
ok on the coax test sounds good. My mount is the pro comm style you use an allen wrench to tighten it up in the factory hole in the mirror arm. I...
No I have not tried another meter yet, but my internal SWR meter on my Galaxy dx98VHP was bouncing too high. I am afraid I may have done damage...
Oh ok, I thought I saw a video on testing coax was to put ohm meter on center pin of both ends. On mine, putting tester leads together results in...
The SWR is running about the same at both locations. I have put in line behind the radio, and also before the antenna. I tested the coax, and it...
I am getting 2.5 on channel 1, and 3.25 on channel 40. Way too high, and I have the stinger all the way in on a 4 foot fiberglass firestick...
Yes, that is what I plan to do when I get back to the shop. Thanks
its a 2006 peterbilt 379. Something in my SWR has changed, and my antenna and coax test ok.
Does anyone know if the mirror ground wire is good, as long as it will light a test light off of the batteries? I am struggling with a high SWR,...
Hi Guys I am in the market for a new cb antenna for my 2007 379 Peterbilt. I have been running a single Wilson 5000 on the drivers mirror arm....
Still working on this project. I now have 3 broken exhaust manifold studs. Call me crazy, but i just thought i would ask, could my...
Yes PDI is telling me almost 2300# of torque, that is why i didn't know if i would be pushing it with the eaton 2250. I can buy the eaton...
Thanks for all the replies! I'm not positive, buy I think I will have to change the input shaft no matter which heavy clutch I go too. I will...
My last dyno test showed I am getting about 670HP at the rear wheels. I have a Cat C-15 factory 625hp with a PDI system on It. 18speed...
No I have not gone back to a factory tune yet. ECM is new with a PDI tune on it. I am trying to figure out how to get a different ECM with a...
Engine harness was new with overhaul. Flywheel is new also. I agree with rear of trans, but I can't see anything. I put new rear yolk on to...
Still looking for the issue. A friend of mine just mentioned the cam shaft. Would a Platinum overhaul kit include the Cam Shaft? Maybe this is...
Well I am still at this crazy issue. Does anyone know if an out of balance clutch, or flywheel could make a cat engine run like it is out of...
No, PTO is only engaged when I am pumping off. I do not know the internals of an Eaton 18 speed transmission, but I had a guy in the past tell me...
Thanks for everyone's ideas! I did go back into the shop again, and as usual " They Know What i am feeling, but they just can't find it." They...
