Update: So yes check your H rings. Ring on five intake was loose. Looking down the tube looked fine, but double checked pushing an extension up...
Thanks. it didn't have that in my manual.
I was calling it the wrong acronym. I work on everything, not just macks/volvos and I do mix up the acronyms often. My mistake. And yes it does...
Yes I can complete a regen and an scr sublimination test without issues. It will set faults for any of the after treatment sensors being...
Also the customer did take it to a mack dealer for this scr issue and they swapped the afm with a test module, but still had the same results.
Have a 2013 Mack CXU that is having some SCR efficiency issues, but while doing the tests discovered a communication issue as well. AFM does not...
Final update. Pulled the oil pan and inspected. Cam lifters were broke which is why the adjusts were outta wack trying to reset overhead. Gonna...
As for the dash bulb...check the fuse panel if it has an abs indicator fuse. Some trucks have them. Also double check that the cluster doesn't...
If the speed sensor doesn't moved...its either already bottomed out or seized. If you can see it then grab it with pliers and try to rotate it....
The mid 136 sid 2 fmi 1 is for the right steer axle speed sensor reading below normal. Most of the time the air gap between the sensor and the...
None of those programs will connector to a Wabco abs system. They would have to use Wabco or a universal program like JPRO to read the codes....
What program are you using to connect to the truck? And do you know what abs module it has in it?
Sounds like ya lost your data network communication. What was the fault code on the dash display?
Uploaded some pics for a visual. The 1.14mm(0.045) feelers are put in under the plunger and inside valve tip. Push tube turned till spring seats...
If you're talking about what's in the center of the picture with the two wire connector on it...it looks like the egr valve. But, the camera focus...
Also have had the air inlet pipe for the turbo off during running and the egr inlet pipe to eliminate a stuck open egr valve. Don't have access...
Yes. Have had turbo intake off during running. Also have popped off the egr pipe to the intake to eliminate a stuck open egr valve.
Is there a way to pull the lifters up through the push tube hole to inspect them and the cam lobe face with a borescope? I've tried with a...
Needing some pre-volvo Mack expertise assistance Symptoms: low boost below 10psi, black smoke, not running smooth but not a dead miss, low power,...
Did both gauges start having issues at the same time?
