Thank you
Yes all original cummins/freightliner nox sensor with same part#. Shop talk says to check the relay and the 10amp relay that powers this nox...
Update * I had a mechanic check the power to the sensor and all showed fine. I replaced the sensor yesterday and code still remains. Any help is...
Hey Everyone, My 2011 Freightliner m2 with a cummins isc 8.3 recently threw code 3232. Basically issue with power to inlet nox sensor (mounts...
UPDATE* It has been almost 2 weeks since I blasted out the dpf with water and air and almost 3 weeks since we installed a new scr catalyst. So far...
Blasted out the dpf with water and air yesterday. I will post in the next few days regarding the hg #'s
I did a forced regen the day before we installed the scr and got the hg to 0.8. The days following after we installed the new scr were 3.5, 3.7,...
I will check def % today (running name brand stuff) peak I believe. Def filter was changed last year I did not run a regen with scr off. I will...
Is it poss Is it possible to have a fautly scr with no sign of face plugging (maybe something behind the fine mesh)? When we completely pulled...
Update* After checking the def doser (everything was fine), I went ahead and took the bullet and ordered a new SCR filter $3200.00 bucks! I am...
Even with a bright light its going to be very hard to get any view of inside the catalyst with those hole sizes. Also today the 3582 and 3543...
Do those pics of my scr and doc look okay? Should I be worried about that little dried up def around the rim? Thank you
Installed the outlet nox sensor today. I also dropped the scr catalyst down and did a visual inspection (no face plugging seen)I posted pics of...
Found it for $350.00 with core. I will install tomorrow. Thanks again
Attached is my nox outlet sensor. Anyone have a cummins cross over # for this? Also does this seem to be a factory sensor or even the correct one?
Yes I found some for around $300.00 and change. Is there 1 of the 2 you are leaning towards being the problem (inlet or outlet)? I was going to...
I try to always be sitting down when I get quotes from Freightliner.
Okay so basically replace the inlet and outlet sensor since removing requires a torch and will prob damage...my brother had to remove the inlet...
Could you go into more detail regarding reading the ppms during regen to rule out a bad nox sensor ,where can I find this value? Thanks
The electrical gremlin i had issue with before have been fixed as we have gone 8 days without the electrical issues we were having before. Thanks...
