Does anyone know the torque spec for the injector hold down bolts when replacing both injectors and stainless steel injector cups?
So then sometimes if your dealing with NOx codes just replacing the DPF with a clean one is the best fix?
I am also dealing with these issues I was wondering what you mean by SCR (poisoning) thanks!
Volvo techs... can anyone tell me while the truck is idling (say while the driver is sleeping) does the egr valve stay open or stay closed or does...
I know you said its not a sensor but I would replace both the oil pressure and crankcase sensors they can cause problems.
Haven't found any cracks yet but thanks for the suggestions!
I have a 2013 volvo VN with a D13H in it and the truck will not complete a parked regen it keeps stopping midway through and says SCR temp too...
Question for any volvo techs. The egr valves have 2 oil lines one goes to the rear of engine at flywheel housing and another that goes to the oil...
switches are not lighting up when I turn my headlights and dimmer switch is not working on I've already replaced the headlight and dimmer switch...
well I just replaced injector cups how necessary is it to run an overhead? I'd feel better if I about it if i did! Any info would be great!
Does anyone know the procedure/specs for running an overhead on a d13h model?
2010 international daycab model 8600
Trying to set up a suspension air dump valve for this daycab. Does anyone know if you can buy a kit to install.
Have your mechanic reach in and grab the bullgear (which is what drives the air compressor) and wiggle it it should be tight with no play (they...
If you are paying for this out of pocket i'm very sorry chances are if you caught it in time the compressor itself is ok mine is im just replacing...
its a common issue with the d13 pretty big job you have to pull trans, rear motor mounts and flywheel housing off
More than likely the bull gear backed off and caused the air compressor gear to get chewed up like that. I'm guessing you heard the engine start...
Anyone know the torque specs for the bolts back there? The nut backed completely off the bull gear and started rubbing on the flywheel housing the...
I would definitely this was the silicone e hose (green) connected yo the bottom side of filter twist it around and pug it ono the Inet side of it...
for a temporary fix you can take a 1 inch rubber hose and loop it around from the inlet to the outlet of your crankcase filter then just run a...
