Hello everyone, I am having trouble with my blower motor not blowing as strong as it should in my truck. I have replaced the blower motor and...
I would recommend calling big rig power out of Edmonton. I am pleased with the tuning they did, and have put 60,000 miles on the truck since doing...
Just wanted to update this thread and close it out. The shop found the problem just minutes after I showed up with my rental truck to get my...
That is true, its not the cost of the repair that is killing me at this point, it is being in the shop for almost two weeks without any income at...
I just said the same thing to the shop manager where the truck is.... fingers crossed that is the problem. It matches the two codes that we are...
It has a traditional jake on the engine, but if I'm not mistaken also uses boost pressure to add to the jake.
If I am correct the engine brake is also augmented by an exhaust brake on the mx-13. I know the turbo spools when the jake is on anyway.
What do you mean the engine brake is stuck? Like the brake is physically stuck open or closed on top of the engine and holding valves open?
Thank you for the response I will pass this on to the shop. I am afraid I might have to take it to someone I trust. Do you think it will be okay...
Certain parts have fallen off. I have had no problems with it for the last 50k miles however, so I am hesitant to think it is the tune. I am...
Update, the engine is giving two codes: P2544 CAN communication - Message (PROPB_VIC) data error, Engine brake switch from vehicle control system...
They changed the fuel filter out this morning, checked the exhaust side of the turbo and said that its fine. They are going to check turbo speed...
Nevermind, figured it out.... just fault codes
Also, what is a DTC?
Been doing some online research, do you think a faulty turbo speed sensor could cause the turbo not to spool? Also could a problem with the jakes...
Is it possible the shaft snapped, but no oil leaked to cause smoking? It is not smoking, no codes other than the ones I already mentioned. Could...
If anybody can give any suggestion as to what could be wrong with my truck it would be much appreciated. I just got loaded and was merging onto...
Hey everyone, I have been researching getting into heavy haul with my next truck. Right now I run a flatbed. I have been looking at different...
I say go for it man, drive for a few years, save some money and go for it. I have been running a flatbed with my own authority for 3 1/2 years...
I had a similar problem with my truck, ended up being the air drier not sending signal to the governor on the compressor to shut-off. There is an...