How much did International charge to program it? Dealing with very similar issue on a DT530E
I think I’ve narrowed it down to the clevis/yoke ends were the pushrods attach to the slacks binding due to road salt. I soaked them all with...
I took note of an offending brake yesterday, this morning we took the "parking brake" line off the camber and pushed in the red supply button,...
0 psi on control side
it is above freezing now and these trailers are a loooooong way from needing bushings…. This sounds very plausible.
Set of Timpte hopper trains, new in 2017, not a ton of miles on them, yes always greased. I have some brakes starting to want to drag, like the...
talked to my mech buddy, looks like that’s where we are headed (pun not intended) No coolant in oil so I guess I’ll keep running it for now.
:(
Took of from shop loaded (160k) after a 20 minute warm up at 1000rpm at about 20°F ambient. few miles down road truck starts to push coolant...
Update. Replaced with a new 250psi valve and all is normal last 400 miles.
looks fine to me. Headscratcher.
I have not. How does one go about testing the unloader?
governor has been replaced, I will look into purge valve thanks.
yes I have replaced the pop off valve
:(:( I’ll let ya know got a friend who recently went out on his own as a mobile wrench coming later this week to re seal injector cups
It was 150 or 200 I’d have to double check
yes I am, ive already had to replace one because it wore out from popping off and wouldn’t hold.
yes it did, the valve pops at those pressures.
It is the safety valve, for sure. Pressure on the the gauges is usually 110-125 I've run shop are through the main discharge line and it...
2006 T800 with 2005 C15MXS motor. Under acceleration the compressor safety valve sometimes will pop off. Running the truck in the shop the...