Are you flipping to high range you're still in gear or while in you're in neutral?
Peterbilt's part # (2) rings = R41-6009 (1) boot = T09-6002...... You'll be able to check prices with your local Peterbilt
You need to chase down the center pole power on your electrical cord following it back toward your dash. Some trucks are switched for the center...
There should be numbers on the pinion shaft tip where the yoke bolts on. You'll have to really clean it to see it, but it's there. mine had 10...
I'd call Henry L. Velasquez (213-276-0157) in Cali. They have a lot of used 359 parts when they can't save it. and/ or dansshopinc.com...
You should have a blue AUX wire behind the passenger side dash in the main harness.. I hooked mine to a spare rocker switch.. I use it anytime I'm...
It looks like this setup! http://www.donvel.com/steer-axle/
Not sure where I got the pic... I found it on Facebook 6 months ago.. I can't remember which or how much of 359 and 379 hood was used...
Hartford (Livestock Transit Coverage)
Sparkman's in Quanah,Tx
I'd check to see if your getting power from your hvac on/off toggle to the A/C thermostat switch, then chase wire from there to your trinary...
Probably Too late for rods and mains.. The knock is mostly likely a gauled piston...
I'd clean the filter and evaporator and heater core first, and check and make sure no cabin air is escaping at firewall around the heater core and...
I had to open the holes up a little on my 359. but other than that... It's pretty much straight forward with the instructions..
I use State Farm for my farm truck and trailer. They were the half of the price of Farmers but that was 2012. And I payed by check to get started...
I would suppose they would. Maybe add alittle silicone to seal it in... I found these after a quick search....
I'd fill it with a flush rubber firewall plug .... probably be cheaper than JB Weld
No problem.. I was really surprised after I pressured and found more.. mostly at the weld seams behind the u bolts..
My axle cracked at the same place and along the weld seams last year on my 402s. I removed the suspension and u bolts, so I could get in there and...
Have you checked the bulbs in the dash warning cluster? There should be a buzzer too, right in the middle of that cluster. I found a buzzer...
