I have Peterbilt truck with Cummins ISC tried to start it but no luck, active fault codes as below and I checked all connections for the 6...
Hi, Please advise the best bearing type and PN used for replacing tensioner and idler pulley for Peterbilt with Cummins engine ISX12
Please any info for this type of filter?
Hi, I got a used Peterbilt truck and when check engine side I found a kleenoil filter installed to on the engine bay Any idea what this filter...
I have 2014 Peterbilt truck with Cummins ISX12 I got engine oil leakage through exhaust manifold Turbo checked found ok then removed exhaust...
No I want to do it by 3rd party. Yes I will keep Artex body Do you know a shop to do that?
California
I have 4X2 truck and I need to convert it to be 6X4 one to be able drive safely on rough roads Any idea how this can be done? 123_1(19) by...
I have MACK Granite CT713 2007 Dump Truck. I need to drive this truck in desert with soft sand. Is converting the truck to 6x6 will help...
I have Peterbilt 365 Truck with Cummins ISX12. I always have a problem that the soot is build up quickly and the warning lite is on. After the...
After Testing the X1–6 to X1–24 found it was 4.5 ohm but when tested X1-6 to C it was less than 1.5 ohm and C to D at cylinder head cover injector...
Thank you I found short on the IDM relay connection 86 But also I have 422 & 425 with hard starting in the manual it indicates a harness or coil...
I have International Truck 7500 model 2006. The amber engine is shown and the truck cranking but not starting. The engine give errors 525 & 534...
In my DT570 engine I tried to remove the camshaft gear to replace the rear half front cover. I used a puller many times but the puller always slip...
If I disconnected batteries and wash ECM area and dried it very well is that also will affect ECM. Because ECM is very dirty.
My engine international DT466 is very dirty (dust, oil,...etc) and I need to clean it by wash gun. I need to know what parts should I cover before...
Hello Heavyd I bought nexiq tool to diagnosis my truck. Now I clear codes and make a KOEO Injector test. the DTC code show 422 & 426. Is that...
Hi, I observed engine oil leakage coming from the bolt hole of the front cover (2L in 3 days). What do think is it from the bolt or from the...
DT570
Hello, I have International Truck 7500 and the spare parts are not always available in my country. So I need to keep the most important spare...
