Can find info on Google, so here I am. Where exactly is the crank position sensor on a 2015 volvo D13?
I have a 2015 volvo vnl630 with 12 speed ishift. It has oem seats, with the electric shifter mounted on the drivers seat. I need an aftermarket...
Just bought a 2015 Volvo vnl630. I noticed dried def fluid on the exhaust stack. Is that normal? It's my first def equipped truck.
On low and hi, motor works fine. Delay is random, halfway up the windshield then back a little. Is the delay module in the motor or somewhere...
Replaced my solenoids, Jake's are now functional.
This noise / miss is happening all the time, with jake switch off.
I have a cm870 cummins isx. Jake's don't work. I have verified the dash switches are working using insite. Wiring to solenoids is working. When...
As a backup, I recently purchased a replacement xy shifter for my eaton ultrashift, used. I bought part "A-7034" which I soon found out is for a...
I adjusted the intake, exhaust and injectors. Didn't touch the Jake rockers, other than check to see if detent still holds them in place. I used...
Hello. I have a 2006 isx 435, which just passed 800k miles. Jake's dont work and valves seemed to tick a lot, so I pulled the cover to adjust...
My clutch discs had a bit of oil on them, when removed. Shop said it would burn off and clutch would work quietly for a bit, then rear main would...
Lol. Grinding came back again! I took it in this weekend and had the whole clutch, input shaft kit and rear main seal replaced. It's so much...
I have an 07 9200i, its cold when I turn the temp below half, and hot when over half on the temp dial. There is no in-between... Would this be...
I think I found my issue. I had a shop install new exhaust and the solid pipe connected to the turbo has been rubbing the frame. This is a thick...
I have a 2006 isx 15, 435hp, and have been hearing gear train noise, and decided to remove the front gear cover and check things out. The truck...
I have a 2007 9200i, with the isx. When I start the truck in the morning, it takes 5-15 minutes for my volt gauge to rise. After that, its...
I plan on checking the overhead cam timing soon. The compressor is timed to the crank correctly, I verified it by removing the oil fill tube,...
Hello all, I am sure that many with the cummins single stage compressors have (or will) experience an issue with knocking. Mine knocked like...
Maybe scrapyard markings?
It was a fleet truck.
