I had a 2012 Freightliner Coronado give me grief one time. The Emissions system kept trying to regen the system and failing each time giving the...
Perhaps a connection from the battery to the circuit board feed is broken, maybe a bad fuse or a loose/corroded connection.
If not wait till it does, or it maybe never will.
Is the pressure from the test port show any fluctuations? If a bucket of oil is held with the pickup tube when the pan is off, does it come out of...
There are normally three wires to an actuator. One for Power, One for Ground and One for output to the computer for actual positioning. When the...
I would ask.. Does the seal leak where this "play" exists?
Best advice is check some fuses. All of them! Go along with a test light while ignition on and engine running and check for power on each side of...
Yes they do have shims on the outside bearing retainer on some. And yes they can be addressed that way, but you would want to know what created...
Up and Down play is normal apparently... and (rotational) play should only be a certain spec. I would imagine the up and down (lateral) play is...
Can't trust nobody. Lots of posers out there.
Doesn't mean the same guy is still there, or had an apprentice complete
Cylinder contribution tests or other automated tests on the laptop or scanner will tell you (not always right).
Your supposed to have the engine set in two particular places when you do the adjustment, so there is that. And the measurement is done by feeler...
Go back to the shop and have them hookup to the ecm see if there is any tell tail signs. If there is nothing, have them reset the ECM to delete...
If you are a mechanic those sets come in handy all the time.
Was the system holding charge before you put the new drier on?
With plastics, Go with your gut and hand feeling. If it Leaks and doesn't need an o-ring, then most likely the pressure switch. But looking at the...
Over Revving will take your rockers and send them out of oblivion!
Not much really but you need to set the new one to spec by getting the timing gear in the right position so there is no tension from the lobe on...
C15 Sucks ### and so does the N14, Old Technically Obsolete Injection System very similar to your Series 60 11L... I would soup up your 11L, that...
