I have a 9800 International with S60 detroit engine. The gauges in the cluster jump up and down and spin all the time but as soon as I plug in an...
The light has been on for a couple months now but owner wants it fixed now
Yea it is a hassle. I attached the diagram for power introduction to the ecm if it helps. Also I'm still not fully convinced that something is...
Can I force it to turn off from the software ?
When is it shorting out.. while you drive or as soon as you connect battery cables? I'd start with the power harness to the ecm as it gives...
Abs lamp on but no fault codes as in attached picture. 2004 KW T2000 Any ideas?
Clean both positive and negative side power. Clean all battery post terminals, battery negative to chassis (or from starter to chassis), chassis...
Thanks yea that’s certainly a problem with vibration. I had another truck with wheel wobble from a bent rim and you could almost predict when that...
Thank you. Something was up with that sensor even though it showed normal resistance and pushing it in closer to the time ring didn’t fix the...
No problem will do that. Thanks for all your help!!
You’re absolutely right! it was a wrecked truck with broken windshields. One more question, the trailer abs which is wabco shows blink code 6,...
So looks like the abs Ecu is bad. The relay diagonal is actually inside the ecu. After taking apart that case, there was water damage in there....
Awesome! I will check when I get to it again. The fuse box you mentioned is the one by the pedals correct? Because the under hood box is only...
So does the vin number tell you anything?
Thank you for the advice. So i checked resistance across the two pins of the fuse with power off and they both showed 0-0.1Ohms resistance. Other...
Thanks I’ll get the vin to you later today. I checked the main 30a fuse and 5a abs ign fuse in the fuse box by the pedals and they seem to be...
Hello I have a 2014 Pete 379 with a detroit 12.7 glider series 60. There is a tractor abs light for diagonal relay 1. Abs is bendix ec60-pre. Does...
Yes sorry by tapping off I mean I had a voltage buffer to use to not mess with the original signal so basically it copies what the ecm sees...
Thanks for sending that. There was no sensor I could use for the dash gauge so I tapped off of the signal of the water temp sensor to the ecm
Can can you send me that whole diagram please?
