I replaced the Starter and no issues now. Thank you for your all's help Vary Much!.
It does. However stops on the 6th or 7 runs then flashes the 20 Code
It will start and run maybe 6 times then on the 7th it won’t I did notice the starter Grinds when it does it
It’s a Isuzu
Voltage is 13.6 oil is 63 psi coil 32.6 the Amb air don’t work. Rpm 1600 DDUR 43 Hours 35218 water Temp 184.3F Amps 0.8
I will look and see. I thought maybe it was vapor locking . Once I clear the code and flip at the manual it starts just fine .
Thermo King SB3 + Started throwing A Code 20 and will not start in auto start. I replaced the fuel Filter but it did not fix the problem, After I...
It was the RPM Sensor! Getting 1200 RPM reading on gauge now. Starts and Runs like a champ now. Thank you vary much
Ok thanks
All terminals are clean. I will get a new censor and see if it changes
Is it this where it gets the RPM reading from?
Is this what it gets the RPM from?
I’m not seeing any green on it
When running rpm says 41 on gauge
Are you referring to this as the main board?
I also cleaned the brushed off the Crank shaft sensor. Is there a way to check it? I’m going to run a couple of jumper wires to make sure they...
Starts and run great!
My SB III R+ Starts and runs fine but in Auto start Cycle Mode the Starter stays engaged after the Engine starts. I have swapped the start relay...
