Yes just the pump , but no he showed me it was just pump and said over 2k didnt really even show me exact amount... I ve searched the webs with...
Hi, looking to replace the injection fuel pump that gears to injector shaft thats bolted to top of ifsm for cummins isx cm570... Rush wants 2k so...
UPDATE: so I replaced the one timing actuator that had 1.5 ohms resistance. I took it off again before picking new one up at cummins. Check...
Had few issues on not just my cars but 3 trucks.. with cars just.like heavy d says, the park ability is built in to motor (some makes have a...
thank you for the look up Heavy D , going to start by changing out the worse one since they are pricey ,will ask to inspect prior to purchase and...
Had same issue in a 2011 prostar . Like heavy d says it can be caused by any wierd electro issue. Mine seem to go away after replacing all the...
Hi everyone, so I did the rawze inspection (somewhat) on my metering and timing actuators off of the ifsm. My truck is a 2002 9400i cummins isx i...
After reading alot of post, notice when these compressors leak oil is usually into air tanks.. My issue is engine oil leak between compressor...
Maybe noise from bellhousing
nys requires lamp and audible alarm for reverse. dont matter if your out of state if your in NY your required to be in regulation. doesnt matter...
Quick trick i was taught back when i was a mechanic for xhrysler and hyundai . even in manufacturer schools it was a "one of the quick chexks"...
So in previous post one of my issues i thought culprit was body controller, due to wacky voltage readings and alarms at gauge. Ever since i...
So i will do resistance test on thermistors tomorrow but from im reading bad thermisters cause compressor not to kick on . Now i turn ac on...
Update with hvac controls... Found mode selection for vents actuator had broken section of sleeve.. i reinforced the blend actuator with epoxy...
Update 4/23... replaced multifunction switch, fixed the wiper issue .. thanks heavy d. Gonna have a guy run scanner for hvac issues
im having same issue , try this just to see if it moves after reset.. with key on position engine off,,their are a few fuses that say for body...
UPDATE: brought the multifunction switch home and after pulling the boot on stalk back the white connector (not the main connector to truck...
Im going to take a look at it tmw. is 50 ohms resisyance normal at ground post on passenger side ? When i disconnect all bcm connectors.it drops...
it just hit me that when i have the switch plugged in and in off position, it cycles wipers on lowest setting and I see the signal when the power...
