We managed to fix this without much issue at all. The rubber gave out on the old rear driver's side mount (see pic) which caused the bolts to snap...
Thank you for the link! I actually have that service manual and was unable to find anything relevant to those mounts. I am mainly wondering how to...
Hello, Would anyone happen to have a guide on replacing the engine/trans mounts on a 2006 Volvo D16 or similar (D13 and D12 would probably be...
Hello, I have a 2006 Volvo D16 VT880. I decided to replace my relay valve and two ABS valves due to a small air leak occurring at the exhaust of...
Just an fyi to anyone reading this post, I purchased new bolts and was able to torque them to 46ft/lbs and apply another 120 degree angle turn...
Do you know if Clutch bolts are the same way? I'll go and grab those as well if they are. Thanks
I have purchased new bolts and after reading these replies, I am glad I did. Thanks!
You dont sound like a ######## at all. I agree with you. I feel like I'm going to snap a bolt if I go any farther.
And nothing in the manual calls for new ones
I am using the old bolts
Per the Volvo service manual of a 2006 D16 Volvo VT880, the flywheel bolts should be torqued to 44ft +- ft/lb and then another 120 +- 10 degrees....
Hello, I have a 2006 Volvo D16 Vt880 with an eaton fuller transmission. I am replacing the clutch and am wondering what the torque specs are for...
Hello, I am wondering if there is any diagnostic software available for a Tripac ThermoKing. It is not an Evolution. Thank you
Hm... reasoning behind it? I'm confused as to how that would even be possible. The plug can only be inserted one way and I haven't tinkered with...
Hello! I have an issue concerning a ThermoKing tripac apu (don't we all) and I can't quite figure out the solution to it. When I first power on...
The compressor is old and will likely be replaced soon. I did drain a bit of freon and it did seem to help. I will run the motor again tomorrow...
Would the injection pump have anything to do with it even though the motor runs completely fine when blowing heat instead of A/C?
Brand new fuel pump as well
Yup both fuel filters have been changed along with the oil filter
Idle is already at max
