This guy throws numbers around like He’s some authority on the issue. FFS, I skip over his posts by page 6 on a mobile phone. 75% of who? Biden...
Installed IDM around 3:30 this afternoon. Truck fired right up. Thanks for the advice Heavyd. I couldn’t afford to be wrong after a fiasco I had...
Well Heavy, I loaded all the grounds AT IDM and have good continuity on the CAN2 from IDM to ECM. Loaded all the power supplies when I ground pin...
Will update when I have it fixed. Thanks for the advice.
So , if I unplug connector X3 at IDM, and jump pin 27 relay clicks and I have power at all the pins I need to have power at. Pins 4,8, 23,24,25...
Ok, will do. Appreciate it. It does have the code 543 SPN 155 FMI 7 active currently. That’s the ECM/IDM communication fault code . Hard code, as...
It might be 2 volts on CAN2 pins 30/31 at connector X3 at IDM. IM USING A MULTI METER, which isn’t ideal. I know. I think it might be averaging...
Good evening. 175k dt466. Replaced 6 injectors, icp sensor, valve cover gasket, high pressure oil rail seals, lift pump ( leaking into oil ) ,...
If your cluster is still dead, no wait to start light etc, There’s a 5 amp fuse inside the cab on passenger side fuse panel that’s probably open....
So, it was my first rodeo with the HPB Wabco brake system. Oddly enough, I’m pretty certain the abs module lost its parameters somehow. Jumpstart?...
Also just for the full picture, that code capture is right after I put Wabco EBCM back on hcu. Earlier code capture didn’t have the ground...
Thanks for responding! It runs pumps straight away as designed with good pressure on both channels, front and rear straight away. 1800-2100 psi. I...
Hey, seen many of fixes on this board over the years. HeavyD , I’m going to be bald by Monday if I keep second guessing myself. Truck will not...
