Good day all, and I want to say thanks to you folks reading this. So with all the help I received here I was able to isolate and repair the...
Trying to figure out how to delete this post. Looked at Fuller's website for approved transmission fluids for my 5406N and found Mobil Delvac 1...
The time has come for another clutch fluid change in our Fuller 5406N. I am curious to know if anyone else has used Mobil Delvac 1 in their...
I pulled out my fuel pressure regulator and about 3-5 Tbsp of what looked like motor oil slowly trickled out. I would expect fuel, not oil. I...
Well, the truck is gutless, so I'm going to blow out the pressure restrictor/regulator and make sure there is 60-70 psi at the rail first. I have...
Thanks! There was actually a primer pump built into the fuel water separator housing, so that was nice. But now that I have it running I drove...
Oh, one more thing...the fuel pump doesnt turn off. I tried to pick up a fuel pressure gauge but it didn't have the right fitting so Im going to...
UPDATE: I Installed the fuel filter/separator (it appears they are the same thing?) and in the process drained the housing that holds the fuel...
Thanks for the reply How do you do that? I did get it to start (but batteries were bad, I didn't know it at the time, I just replaced them...
Good day, I have a 2006 International Durastar with a DT466 engine. Recently we have had problems with it going up hills or going faster than 55...
Thanks everyone for your suggestions, I appreciate it! Inderjit, I will see about removing the restrictor and replacing it. Im going to replace...
It's been a few years since I worked on a diesel engine. Now I remember doing maintenance on our old Freightliner and replacing the fuel filter...
Thanks for the quick response! Do you know if that would cause an intermittent CEL?
I have a 2006 4300 series Durastar with a DT466 engine. It has almost 300k on it, but still looks clean and drives great. Well, it used to. A...
Thank you Star Rider. I am dropping the truck off Friday at a well reputed shop and leaving it with them over the weekend. I will post the...
Good morning all, thanks for reading. I don't typically operate on diesel engines, but as maintenance manager I have been doing more and more of...
