I understand how the pto works. As stated in my first post, I did replace the sensor with zero change. The puzzling part is that it works sitting...
Works fine while parked. Does not work going down the road. That is where I get the press and release clutch pedal is moving down the road.
Can someone tell me what was the cause of the " press and release clutch pedal before setting cruise" solution is? I have a 2014 pete 388 with an...
I know this thread is old, but what was the cause of the " press and release clutch pedal before setting cruise" solution? I have a 2014 pete...
Not necessary but much easier, yes.
Likely your code is for the steering angle sensor. Then only way around that would be changing linkage before the sensor and getting it spot on....
Bpv will help the engine warm up by creating back pressure and holding more heat in the engine. This is needed by egr, during regens or cold...
That is where the bellows between the egr valve and egr cooler goes. Egr valve is mounted to exhaust manifold. I'm not sure what to tell you...
That cylinder is for the turbo BPV. Back pressure valve.
I have used cata electronics for a couple of Car ecms. One was reman off the shelf the other was repaired. Worth a call. CATA Electronics |...
Well, apparently the $270 cable i bought from snap-on didn’t work. So they lied about their product. Found a guy with diesel laptops jaltest. He...
The older isx used a thermostat for the oil cooler. Not so sure about the newer ones, but the reliefs might be something to check out. Also,...
Truck was built is August of 2018.
So, the ESA troubleshooting suggested I replace the turbo actuator after it failed both parts of the effort test. I did do that but ESA does not...
Was or is there a check valve in any of the fuel filters? There is usually one on the davco suction side.
You would have to get new injectors and possibly the entire valve train (would have to compare esn's). Then rewire engine fan control and engine...
That's worth a shot. Coming off anyway. This thing is very sooty and blows alot of black smoke. Might be the reason.
Resealed the exhaust manifold 10 months ago for leak at head. 3 months ago I replaced the exhaust manifold with an updated oem manifold. New...
Which connector? What is that pin for? I don't have a schematic in front of me.
I know a delivery company who is contracted to bring their service work to a certain dealership. Their units get priority and a discounted rate....
