Pm me your email. What your after is the 7cz aus file. Mods......Nothing illegal about talking about stock cat flash files?
Manufacturers actually have hr meter service intervals as well and base it on how hard the rig is working, idling vs pulling heavy, etc.
Factory built 1.58 bw turbo......say what?!
Do a Manual cut out test with cat et and make it run on 1 cylinder at 1000rpm, watch the electronic rack position for each cylinder and abouts...
I can hook you up if you'd like, pm'd you.
Unplug it and quit wearing your motor out. Do you really like the idea of your engine eating its own poo? Take the mixer pipe out and free up...
I've replaced well over a dozen of those (not on the same rig, but amoungst a fleet of cats), super common to break.
http://www.thetruckersreport.com/truckingindustryforum/trucks-eighteen-wheelers/174497-building-a-6nz-any-suggestions-3.html#post2528246 I...
Monaco tool sells that jig that Morehp posted a pic of, with a special diamond bit drilling studs even at the back of the head is super easy. I've...
Lol, I'd check the air filter first :biggrin_2559:
Cummins oil thermostat opens at 235 your well under that temp, you need to be plugged in with insite and diagnose code or monitor what your...
I had something similar after tuning was done on a 2250 and I found it was the governor type parameter (insite) was switched to variable 1, and it...
Too bad you were north of the border I know a guy who knows a guy thats sitting on a pallet of take offs.
No charge air system leaks, egr delete tune was done prior to me owning the truck but its unplugged and steel plug is installed inside the hose...
Bang on, thank you sir! checked with insite, engine cold, and turned off and reading for exhaust gas pressure was 66.2 InHg. Checked on a 2250...
Has anyone figured out what is causing this low boost/high egt issue? I have a 870 isx doing this. Replaced the barometric sensor because a actual...
And more sensors.....(in the 2350)
I'd remove it and clean it the old fashioned way, that crap your flushing into the engine is horrible. Cummins has done a pile of inframes in my...
Sounds like your turbo is on its way out, check your turbo actuator position, it's should be 89% or higher. I've had them at 87% and just a tad...
Also make sure the hoses are routed the same height and not dipping down on either side, I have a truck that sometime in it's past the hoses were...
