Flat bars with a round tube connecting them under the axle. The schematic I looked at calls them torsion bars..
I have a w900 with ag400 suspension. What holds the torsion bar centered? The front drive axle is offset to the left by a little over an inch....
94 Kenworth with a DDECiii 12.7 60 series, engine threw a rod out the side of the block. I have a parts truck with a good running DDECii 12.7 that...
I've never messed with the 11L but the 12.7s I have all have a safety shut down for low coolant level. Will shut down the engine and cause a crank...
I am building a 6x6 International paystar. The original spicer transfer case was severely rotted due to being under the salt sand body. I bought a...
I've picked up a mack TC150 transfer case to replace the severely rotted original spicer unit in my international paystar. The mack is a rebuilt...
Was behind the oil fill neck on this motor. Thanks! [IMG]
Thanks! I'll check that out
Just did a clutch on my 2010 t800 with Cummins isx600. Like I always do I put the clutch on the transmission input shaft and slid the trans and...
I'm looking to get a scanner for my trucks. I have a Cummins Quickcheck that I bought for my '10 t800 with ISX. This is my only truck with a...
ohh no kidding. so I guess that's normal then....
Well I got it all hooked up yesterday, got pretty much everything figured out. It can do a lot of stuff, but it's a pretty simple setup to learn....
Some nice trucks in here! We use our trucks to haul wood and wood chips. [IMG] [IMG] [IMG] [IMG]
I'm not exactly sure what he paid for it, I looked it up on the cummins site and it was a little over $1k, but that's full retail, usually can get...
My dad's got a 2010 t800 tractor with the cummins 600 isx engine. we've had some problems with it, some of them just being simple sensors etc. But...
Well I joined the site and have been in the kenworth section, and have got some great help so far. Just thought I'd jump over here and introduce...
I dug out the paper work from the visit when the kenworth dealer did the reflash, and it was indeed C1110 campaign. We're not sure if they...
that makes sense. that's actually what it was doing the first time we brought it down. you could move the yolk with your hand so we figured the...
I was just talking with my dad about what you said about the ecm calibrations and he said that the kenworth dealer just did an updated flash on it...
thanks kaptainkenworth! I'll look into that stuff. what are the ecm calibrations that would help with the egr? probably something the dealer would...
