I have changed out batteries a couple times that's why it has a new battery. This problem isn't something that just started. I have been trying to...
I had the alternator pulled out and it was running 13.6-13.8 on the machine. Thermostat has been changed twice running water temp has been about...
Display unit is only showing 12.6 and I believe the tech had a multimeter on the circuit and said that it was only putting out 12.6 as well
I have a 1999 carrier reefer ultra fresh 2 unit. The unit will not shut off in auto stop start mode. Alternator is putting out 13.6 volts but the...
Number 2 spun on this motor as well. Bearings were in correct. The notches were both in place where they needed to be but the rest of the bearing...
Went to fire it up after we switched computers, put a brand new starter, starter relay, and batteries on and the motor won't turn over now. Tried...
And this is Sanka "feel the rhythm, feel the rhyme, it's kenworth time! Cool runnings" [ATTACH]
BA because he pity's the fool that gets in his way[ATTACH]
Yes it was. We went and looked at it first. You could tell the only thing that got ruined by water was the alternator. No water in the oil...
Thanks guys. I guess in my mind since the two ECMs were reading 460hp I went with the one that was already matched to my truck but I was wrong and...
Those are the engine data plates for each motor
[ATTACH][ATTACH]
Both motors are celect plus motors one is a celect plus ESP the ESP models are for climbing hills
We recently spun a bearing in our n14 celect plus 460hp motor. The crankshaft had micro fractures and was bent. We decided to grab a motor from...
I did them this afternoon and it came out to 305 ft lbs for the 90 degree turn. It was the 140ft lb that had us scared and thinking a 90 degree...
That's for an engine with an ESN 11875596 or older
That's what I was wondering. There are no conversions from degrees to ft lbs but even though a 1/4 turn doesn't seem like a lot I bet it is.
That would be the specs under the crankshaft section and I will throw another curve ball. The bolts are 1 1/8"
So here is my question. We are doing mains and rods in a cummins n14 celect+ with ESN 11964732. Cummins quick serve online has different torque...
Reserve wasn't met. I had the reserve at 3k so if anyone is interested ill let it go for $2750 because I won't have to pay paypal or eBay fees.
