10 Speed Meritor Trans. No Shift from Low to High or back

S3BNUT · Jul 28, 2024

DMVictor said: ↑

Woohoo ! I found a cheap easy cure.

All you need for this is a phillips head screw driver, a piece of wire and electricians tool.

First take off the shrouding below the shift knob.

Locate the 4 pin wires.

Cut a 4 inch piece of wire off.

strip both ends about 3/4 of a inch. ( I used 18 gauge wire )

reduce the number of copper strands to 4 or 5 and twist together

push one end of the wire into and besides the orange wire going into the connector, push the other end next to the white wire going into the connector.

test your truck to see if it shifts into high and low range ..... if it does your done. electrical tape in place, button everything up and start rolling

if not i wish you the best of luck.

THIS IS A NEUTRAL SWITCH BYPASS. BE CAREFUL WHEN STARTING YOUR TRUCK AND MAKE SURE IT"S IN NEUTRAL !
Click to expand...

S3BNUT · Jul 28, 2024

So after years later what was the outcome? Would you recommend a bypass? What happened if you accidently switched ranges in gear?

Log in or Sign up

Forums

Find Trucking Jobs

10 Speed Meritor Trans. No Shift from Low to High or back

S3BNUT Bobtail Member

Trucking Jobs in 30 seconds

Wait, employers can't reach you!

S3BNUT Bobtail Member

Trucking Jobs in 30 seconds

Wait, employers can't reach you!

Log in or Sign up

Useful Searches

Find Trucking Jobs

10 Speed Meritor Trans. No Shift from Low to High or back

S3BNUT Bobtail Member

Wait, employers can't reach you!

S3BNUT Bobtail Member

Wait, employers can't reach you!