Was working fine when we had to replace a brake line on the passenger side front drive. Since then we have air blowing out of the drivers side abs brake valve that attaches to the center port when releasing the parking brake. We put a new drivers side piece on, still blows. Truck was not running when we did this test, as had air hooked up to it if that matters.
Thanks
2000 ABS Brake valve blowing air when releasing parking brake
Discussion in 'Heavy Duty Diesel Truck Mechanics Forum' started by greaseburner, Mar 29, 2019.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
We just replaced the center section of the abs valve assembly. Still blows air out the drivers side and now blows air out of the center section as well.
It's on a 2000 379 Pete if that helps any. -
Make sure you didnt get the brake hoses crossed. Service port on the chamber closest the the slack goes to the ABS modulator valve. Emergency line closest to the caging hole goes to the emergency valve and will be the smaller of the two hoses.
If plumbing is correct, pull the service lines off at the chambers and release the park brake, if air comes out of the service port of the chamber, you have a chamber leaking internally.spsauerland, Working2party and Heavyd Thank this. -
Yep, air lines crossed at your brake chamber, or maxi leaking through internally.
spsauerland, Working2party and Goodysnap Thank this. -
Bingo. Thanks
Brake chamberHeavyd and Working2party Thank this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.