2003 Peterbilt 379, problems with lights and cruise control

Discussion in 'Peterbilt Forum' started by bigboy2289, Aug 23, 2013.

  1. bigboy2289

    bigboy2289 Bobtail Member

    7
    1
    Aug 23, 2013
    Goldston NC
    0
    I have 2003 peterbilt 379 when I turn my lights on or my turn signal on it cut my cruise control off n if I turn my right turn signal on both of my turn signal come on same goes for the left turn signal but if I unplugged one of them it work like it should and my cruise control stay on please help?????
     
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. Giggles the Original

    Giggles the Original Road Train Member

    sounds like squelch monkies have been in your dash:biggrin_2559:
     
  4. bigboy2289

    bigboy2289 Bobtail Member

    7
    1
    Aug 23, 2013
    Goldston NC
    0
    LOL yea is got me going crazy I never seen nothing like this before
     
    Giggles the Original Thanks this.
  5. luvtotruck

    luvtotruck Road Train Member

    1,978
    1,161
    Jul 30, 2013
    Phoenix Arizona
    0
    Use your arm on the one you unplug? Sounds like a short someplace?
     
  6. Wolfyinc

    Wolfyinc Road Train Member

    2,888
    969
    Apr 21, 2013
    Salem, or
    0
    yeah might be best just to go into a shop and get your wiring checked out, it could of took some damage after 10 years...
     
  7. MrMatt

    MrMatt Light Load Member

    166
    90
    Apr 22, 2013
    0
    it sounds like a bad fuse panel. the 379 petes have a bad problem with the fuse panel going out. the due to the location of it. the lack of space prevent the panel from get any ventalation. and the dirt and moisture from being next to the door on the floor. would wear it out. from the symtoms explained. that sounds about right. if the trck has chicken lights on it. then that is a problem. so first i would check out the lighting harness on the bottom of the cab. and i would look for added wiring behind the front bumper and then once it has been checked. then i would check for added wiring in the cab and sleeper along the floor or under the carpet. drivers would add un-needed interior lighting becuase they think it's cool and ad value to the truck. once done there. i would pull the panels off the dash and check the wiring for cuts black tape, platic store bought connecters. and more extra wirring that was added. the factory wiring for the petes are i believe white. and nothing is very well labeled behind the dash panels. it's basically a guessing game. so pay very close attention when unpluging swithches to check or replace them. you loose the plug for that switch. there is a few more in there just like it. that are dead plugs.
     
  8. MrMatt

    MrMatt Light Load Member

    166
    90
    Apr 22, 2013
    0
    honestly! if your just a company driver. leave it alone and report the problem to the owner. and let them decide what to do with the issue.
     
  9. bigboy2289

    bigboy2289 Bobtail Member

    7
    1
    Aug 23, 2013
    Goldston NC
    0
    Thank you I'm try to do all that day n no im not company driver if I was I want be asking for help
     
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.