3406E Jake Brake

Discussion in 'Heavy Duty Diesel Truck Mechanics Forum' started by Newguy333, Mar 5, 2018.

  1. Newguy333

    Newguy333 Bobtail Member

    14
    11
    Jun 30, 2017
    0
    3406e Caterpillar engine rear Jake brake does not change when activated manually. Front Jake brake operates normally. middle Jake brake pops/sounds whimpy. Any advice would be welcomed
     
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. spsauerland

    spsauerland Road Train Member

    4,296
    10,887
    May 31, 2010
    West Harrison, In
    0
    Sounds like it's time for a tune-up kit in your engine brakes.
     
    Oxbow, SAR and pushbroom Thank this.
  4. A5¢

    A5¢ Medium Load Member

    389
    544
    Oct 30, 2017
    0
    When was the last overhead done?
     
  5. Newguy333

    Newguy333 Bobtail Member

    14
    11
    Jun 30, 2017
    0
    Turn up kit was installed last week new O-rings Springs found a couple of bad Springs. Ran the overhead today engine runs smoothly but when you activate the Jake's manually it does not sound right. The front one sounds like it's only hitting on one of the two cylinders, and the middle one sounds different, back 1 shows no difference when they solenoid is activated mechanically
     
  6. Newguy333

    Newguy333 Bobtail Member

    14
    11
    Jun 30, 2017
    0
    Probably need to take that back Jake off and apart and see if I missed something...... I did also I notice with the front Jake brake solenoid activated a lot of oil came out where the slave cylinder pushes in at the front one number one cylinder but number two didn't have a lot of oil coming out of it... the back one also did the same thing but to no effect. Jake brake did not come on on the back one.
     
  7. spsauerland

    spsauerland Road Train Member

    4,296
    10,887
    May 31, 2010
    West Harrison, In
    0
    Which model Jake you have and what is first three of your Serial number. On your hold down bolts, is only one a twelve point?
     
    AModelCat, SAR and Oxbow Thank this.
  8. Newguy333

    Newguy333 Bobtail Member

    14
    11
    Jun 30, 2017
    0
    340c, 2sw,4 12 point bolts, one big nut
     
    Oxbow Thanks this.
  9. Newguy333

    Newguy333 Bobtail Member

    14
    11
    Jun 30, 2017
    0
    2ws
     
    Oxbow Thanks this.
  10. spsauerland

    spsauerland Road Train Member

    4,296
    10,887
    May 31, 2010
    West Harrison, In
    0
    Did you inspect slave valves? Did you let oil purge for at least 30 sec when adjusting Jake lash?
     
    SAR and Oxbow Thank this.
  11. Newguy333

    Newguy333 Bobtail Member

    14
    11
    Jun 30, 2017
    0
    I will relook at the slave valves and yes I did let the oil Purge while adjusting the Lash...
     
    Oxbow Thanks this.
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.