I picked up a totalled 2012 389 a year ago from a buddy for cheap. Reasons being A) front end was ripped off the truck therefore having it wrote off and B) had no engine in it anymore. So seemed like a good idea to fix it and put in whatever motor I felt like would suit it. Of course I changed my mind about half a dozen times and ended up putting an n14 in it. Now I'm in the midst of trying to make a wiring harness for the engine and unfortunately don't have the factory harness from the truck as it went with the motor. I do have another deutsch plug end and all the pins etc but I need a pin out or schematic of the engine firewall connector (top plug on dr. side of firewall) so I can figure out what wire goes where. If anyone can help me out it would be more than greatly appreciated.