3zj with 160-1130 pistons questions

Discussion in 'Trucks [ Eighteen Wheelers ]' started by Gambino1994, Sep 10, 2019 at 8:28 PM.

  1. Gambino1994

    Gambino1994 Light Load Member

    143
    64
    Jan 22, 2009
    causing a situation
    0
    Is the proper connecting rod needed to use the 160-1130 14.5/1 aluminum piston a different size wrist pin than my current rod? Right now I’m running the 101-0016 16.4 pistons. Would I need a E model rod or a different one than that even?
     
  2. wore out

    wore out Numbered Classic

    11,171
    138,883
    Jun 5, 2013
    CHASIN THE DEVIL'S HERD
    0
    The 160-1131 piston uses the small pin with wide bearing rod. The E uses the big pin


    5YG00466 is a good engine serial number that used that piston factory. Should be able to use it to get a good number.


    Now 9Y6408 will be cast on side of all wide bearing rods. Both big and little pin. I have been through this
     
    Last edited: Sep 10, 2019 at 8:42 PM
  3. Gambino1994

    Gambino1994 Light Load Member

    143
    64
    Jan 22, 2009
    causing a situation
    0
    Ok thanks you kinda read my mind lol, so when I try to find a set of rods I gotta look for the same casting number rod I have now, just with a smaller wrist pin diameter?
     
  4. wore out

    wore out Numbered Classic

    11,171
    138,883
    Jun 5, 2013
    CHASIN THE DEVIL'S HERD
    0
    Yes. Call cat and use my serial number to get a good part number
     
    pushbroom and cke Thank this.
  5. wore out

    wore out Numbered Classic

    11,171
    138,883
    Jun 5, 2013
    CHASIN THE DEVIL'S HERD
    0
    I can remember the last digit on the re man part numbers is 1 different from small to big pin rods. It will be in blue near the cap
     
    cke and Gambino1994 Thank this.
  6. Gambino1994

    Gambino1994 Light Load Member

    143
    64
    Jan 22, 2009
    causing a situation
    0
    Excellent info, and this piston is compatible with or8785’s and my stock piston oilers?
     
  7. wore out

    wore out Numbered Classic

    11,171
    138,883
    Jun 5, 2013
    CHASIN THE DEVIL'S HERD
    0
    No go to the double oiler and put the E model spring in your pump. Use the serial number I gave you for Oilers. As well as 3425 nozzles with a 177148 windmill it will suit you I assure you
     
    cke and Gambino1994 Thank this.
  8. wore out

    wore out Numbered Classic

    11,171
    138,883
    Jun 5, 2013
    CHASIN THE DEVIL'S HERD
    0
    Serial number I gave you is a 460hp peec
     
    Gambino1994 Thanks this.
  • Draft saved Draft deleted